Selecting A Patch - Roland Groovebox MC-307 Reference Manual

Chapter 5 Creating Your Own Patterns and
* You can select a patch for a recording part here, see next
"Selecting a patch to use from all lists" and "Selecting a patch
by category."If you do not want to do so, proceed to step 11.
Perform Recording
11. Press the [PLAY] button.
Recording starts. Now, play on the keyboard pads or
external MIDI keyboard.
* When you reach the last measure, the material is recorded
again, starting from Measure 1. Further performance data is
added as recording is repeated.
12. When recording is finished, press the [STOP] button.

Selecting a patch

a. Selecting a patch to use from all lists
Using the Recording screen, carry out the following
operations.
1. Press the [F1 (PACH)] button.
2. Press the [F1 (LIST)] button.
The "PATCH SELECT" screen appears.
3. Select a patch using the [VALUE] dial or the [INC/DEC]
buttons.
4. Upon selection, press [ENTER] button to return to the
screen you selected in Step 1.
b. Selecting a patch to use by category
Using the Recording screen, carry out the following
operations.
1. Press the [F1 (PACH)] button.
2. Press the [F2 (CATG)] button.
The "CATETORY GROUP SELECT" screen appears.
3. Use the [VALUE] dial or the [INC/DEC] buttons to select
the category of the patch you want to select.
64
4. Press the [F1]–[F4] buttons below the category you
selected.
A list of patches included in that category appears.
5. Select a patch using the [VALUE] dial or the [INC/DEC]
buttons.
6. Upon selection, press [ENTER] button to return to the
PATCH screen.
Part and effect settings in the
Recording screen
You can make part and effect settings without stopping
realtime recording.
1. Begin realtime recording. (P. 63)
2. Press the [F2 (STUP)] button.
In this screen, you can choose whether to make part
settings or effect settings. For details refer to the
respective explanations.
- [F1 (PART)]:
Set part parameters. (P. 22)
- [F2 (REV)]
Set reverb parameters. (P. 42)
- [F3 (DLY)]
Set delay parameters. (P. 44)
- [F4 (M-FX)]
Set M-FX parameters. (P. 46)
* When you operate these parameters while recording, your
operations will be recorded in real time.
(Changes in the "TYPE" of REVERB, DELAY, or M-FX
cannot be recorded.)
* If you simply wish to make part settings, without recording
these parameters, refer to the following "Rehearsal function,"
and operate the parameters in rehearsal mode.