Roland Groovebox MC-307 Reference Manual page 59

20. Short Delay
(Add Echoes to the Sound)
This is a short delay which allows you to set the left and right
delay times independently. You can also move the panning
of the delay sound in synchronization with the BPM.
Available Settings:
- TIME L (Delay Time Left) [CTRL 1]
Specifies the time from the original sound until the left
delay sound is heard.
Range: 0.1–190
- TIME R (Delay Time Right) [CTRL 2]
Specifies the time from the original sound until the right
delay sound is heard.
Range: 0.1–190
- HF DAMP [CTRL 3]
Determines the frequency at which the high frequency
portions of the delay sound will be cut.
Range: 200–8000 (Hz), BYPASS
As this parameter is set to a lower frequency, more of the
high range will be cut, making the delay sound more muted
in tone.If you do not wish to cut the high frequency range,
select "BYPASS."
- FEEDBACK (Feedback Level) [CTRL 4]
Adjusts the number of delay repeats.
Range: 0– +98 (%)
- LOW GAIN [CTRL 5]
Adjusts the boost or cut of the low frequency range.
Range: -15– +15
- HIGH GAIN [CTRL 6]
Adjusts the boost or cut of the high frequency range.
Range: -15– +15
- BALANCE (Effect Balance) [CTRL 7]
Adjusts the volume balance between the original sound and
the delay sound.
Range: D100:0W–D0:100W
With a setting of "D100:0W" no delay sound will be output.
- AUTO PAN [CTRL 8]
This setting causes the panning of the delay sound to move
in synchronization with the BPM.
Range: OFF,
2MES, 3MES, 4MES, 8MES, 16MES
- OUTPUT LEVEL [CTRL 9]
Specifies the output volume from the Short Delay effect.
Range: 0–127
Chapter 4 Setting Effects
21. Auto PAN (Automatically Move the
Stereo Location)
This effect automatically moves the stereo location of the
sound. You can cause the sound to be panned left and right
in time with low notes such as a Bass Drum, or in
synchronization with the BPM of the pattern.
Available Settings:
- LFO TYPE [CTRL 1]
Determines the waveform that will be used to pan the
sound to left and right.
Range: TRI, TRP, SIN, SAW1, SAW2, SQR
- BASS SENS [CTRL 2]
Make this setting when you wish to shift the panning at the
timing of the bass notes.
Range
OFF: The panning will change at the speed specified by
Rate.
MODE1: The Rate value will increase at the timing of the
bass notes.
MODE2: The panning will change at the timing of the bass
notes.
- DEPTH [CTRL 4]
Specifies the depth of panning.
Range: 0–127
- RATE [CTRL 2]
Specifies the rate at which the pan will be moved.If a note
value or measure is selected as the value of this parameter,
the Rate will synchronize with the tempo of the pattern at
intervals of the specified note value or measure.
Range:
0.1–10.0,
2MES 3MES 4MES 8MES 16MES
- LOW GAIN [CTRL 5]
Adjusts the boost or cut of the low frequency range.
Range: -15– +15
- HIGH GAIN [CTRL 6]
Adjusts the boost or cut of the high frequency range.
Range: -15– +15
- OUTPUT LEVEL [CTRL 7]
Specifies the output volume of the AUTO PAN effect.
Range: 0–127
* When the Bass Sensitivity parameter is set to "MODE2," the
Rate setting will be ignored.
59