Chapter 4 Setting Effects; Reverb; Switching Reverb On/Off; Adjusting The Reverb Volume For Each Part (Part Reverb Level) - Roland Groovebox MC-307 Reference Manual

Chapter 4 Setting Effects

Reverb

Reverb is an effect which adds reverberation and ambiance
to the sound, creating an impression of spatial depth. It
simulates the sound of music played in a concert hall. This
section describes the settings for using the reverb function.

Switching Reverb On/Off

Switches the reverb function on and off. You can switch
reverb on and off on any part regardless of the other settings
you specified for this function.
Procedure
1. Press the [SYSTEM] button.
The System Parameter menu screen appears.
2. Press the [F1 (SYS)] button.
3. Press the [CURSOR (up)] button to access the screen for
items 1–4.
4. Press the [F1 (SND)] button.
The "SYSTEM: SOUND" screen appears.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to "REVERB SW."
6. Set ON/OFF using the [VALUE] dial or the [INC/DEC]
buttons.
Range: OFF, ON
There are a number of places where settings can be made that
affect the reverb level and related switches. If the effect does
not work with the above settings, check whether:
- The effect is not applied when the GRAB switch is
positioned at OFF if the MC-307 has been set to use
the GRAB switch. To always make the effect take
effect, put the GRAB switch at ON. (P. 62)
- After confirming that the value set for "REVERB:
REVERB LEVEL" is not too low, proceed with
making the setting. (P. 43)
- Confirm that the "Reverb Volume for Each Part" in
the next item is not set too low.
42
Adjusting the Reverb Volume for
Each Part (Part Reverb Level)
Procedure
1. Press the [PTN] button.
The screen for playing patterns appears.
2. Press the [F2 (STUP] button.
The Setup Menu screen appears.
3. Press the [F1 (PART)] button.
4. Use [F1 (Down)] and [F2 (Up)] buttons to select the
"PART MIXER: REV LEVEL" screen.
5. Press the [PART SELECT] button, then press the part
button ([R], [1] to[7]) for the part you want to set.
* Instead, you can select the part with the [CURSOR (right/
left)] buttons.
6. Set a value using the [VALUE] dial or the [INC/DEC]
buttons.
Range: 0 – 127
About Rhythm Tone Reverb SW
- refer to "Applying Multi-Effects for Each Part (Part M-FX
Switch)" (p. 46)
About Rhythm Tone Reverb level
- refer to "SEND: REV SEND LEVEL" (p. 112)

Making Detailed Settings

Defines the settings for using reverb at a specific level.
Procedure
1. Press the [PTN] button.
The screen for playing patterns appears.
2. Press the [F2 (STUP] button.
The Setup Menu screen appears.
3. Press the [F2 (REV] button.