Selecting A Patch/Rhythm Set; Selecting From A List; Selecting Directly - Roland MC-909 Owner's Manual

Top screen of Patch/Sample mode
fig.2-03
Bank
Num (Number)
Patch/Rhythm
(Patch Name/Rhythm Set
Name)
Lev (Part Level)
Pan (Part Pan)
Key (Part Key Shift)
Rev (Par Reverb Send Level)
Out (Part Output Assign)
Seq
(Sequencer Output Assign)
Function buttons
[F1 (List)] Select a patch/rhythm set from a list (p. 55).
(Patch List)
[F2 (Edit)] Edit the settings of a patch/rhythm set (p. 56,
(Patch Edit) p. 70).
[F3 (Mixer)] Specify the volume/pan of each part (p. 33).
(Part Mixer)
[F4 (Effects)] Apply special effects to the sound (p. 88).
[F5 (Mastering)] Make settings for the mastering effect (p.
108).
[F6 (BPM/Click)] Set the tempo, and turn the metronome on/
off (p. 25).
Bank/Number/Name of the
patch (rhythm set) used by each
part (1–16)
Refer to p. 33
How the original sound of each
part will be output
DRY: Output to MIX OUTPUT
jacks without passing through
effects
MFX1 (2): Output through
multi-effects 1 (or 2)
COMP: Output through the
compressor
DIR1 (2): Output to the DI-
RECT 1 (or DIRECT 2) jacks
without passing through ef-
fects
RHY: Output according to the
settings of the rhythm set as-
signed to the part
* "RHY" can be set only when a
rhythm set is assigned to the
part.
Output distination from the se-
quencer
INT: Internal soundgenerator
EXT: MIDI OUT connector
BOTH: Both of the above si-
multaneously

Selecting a patch/rhythm set

Selecting from a list

1. Press [F1 (List)] to display the Patch List screen.
The currently selected patch/rhythm set (the current patch/
rhythm set) will be highlighted.
2. To select a patch, press [F3 (Patch)]. To select a
rhythm set, press [F4 (Rhythm)].
3. Use [F1] [F2] or [CURSOR (left/right)] to select a
bank.
4. Press [F6 (Select)] to finalize your selection.
Selecting a patch by category
1. In the Patch Select screen, press [F5 (Categ)].
The patches will be displayed by category.
2. Use [F1] [F2] or [CURSOR (left/right)] to select a
category.
3. Press [F6 (Select)] to finalize your selection.
Rhythm sets do not have categories.

Selecting directly

1. In the top screen of Patch/Sample mode, use
[CURSOR] to move the cursor to the patch/rhythm
set name or bank.
2. Use [VALUE] or [INC/DEC] to make your selection.
Patch Edit
55