Table of Contents
Advertisement
5
DV MODE OPERATION
Message operation
D TX message programming
TX messages are available for up to 5 channels and each
channel can be programmed with a message of up to 20
characters.
q Enter "TX MSG" in MESSAG (message) screen.
MENU
MESSAG
(Push [MENU
• TX MSG screen is displayed.
w Rotate [DIAL] to select the desired transmit message
channel.
• TM1 to TM5 and OFF are available.
• Previously message is displayed if programmed.
e Push [ ](LOW) to select the message edit condition.
• The 1st digit of the message blinks.
r Rotate [DIAL] to select the desired character or symbol.
• If an unwanted character is entered, push [ ](LOW) or [ ](CS)
to select the character, then push [CLR](DR) to erase the se-
lected character, or push and hold [CLR](DR) for 1 sec. to erase
all characters following the cursor.
• Push [ ](LOW) to move the cursor right; push [ ](CS) to move
the cursor left.
64
TX MSG
]), (Rotate [DIAL], then push [
t Repeat the step r to enter the desired message.
• Up to 20 character messages can be set.
y Push [ ](MONI) to store the message.
](MONI).)
u Push [MENU
• Available characters
(A) (B) (C) (D) (E)
(N) (O) (P) (Q) (R) (S)
(0)
(1)
($) (%) (&)
;
(
) ( < ) ( = ) (>)
] to return to frequency indication.
(F) (G) (H)
( I )
(T) (U) (V) (W)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
'
(
)
( ( )
( ) ) ( )
( + )
( , )
(?)
( @ ) ( )
( \ )
( ] )
(J)
(K)
(L) (M)
(X) (Y)
(Z)
(9)
(!)
(")
(#)
/
( - )
( . )
(
)
(:)
( ^ ) ( Space )
Advertisement
Table of Contents
