Table of Contents
Advertisement
5
DV MODE OPERATION
Break-in communication
The break-in function allows you to break into a conversa-
tion, where the two original stations are communicating with
call sign squelch enabled.
q While receiving an another station's communication, push
and hold [RX CS](CS) for 1 sec. to set the communicating
station's call sign.
• When a call sign has not been received correctly, error beeps
sound and no call sign is set. Try to set the call sign of a com-
municating signal again, or set the call sign manually.
w Enter "BK" in DV SET mode.
MENU
DV SET
(Push [MENU
• BK screen is displayed.
e Rotate [DIAL] to turn the Break-in function ON or OFF.
• When "ON" is selected, "BK" appears instead of memory chan-
nel indication
r Push [ ](MONI).
• Returns to DV SET mode.
68
BK
]), (rotate [DIAL], then push [ ](MONI).)
t Push [MENU
] to return to frequency indication.
y When both stations are in standby, push [PTT] to transmit
a break-in call.
• The programmed call sign station receives the break-in call as
well as your call sign.
u Wait for the reply call from the station who receives the
break-in call.
i After receiving the reply call, communicate normally.
o To cancel the break-in function, turn the Break-in function
OFF in the DV SET mode as steps w to t.
NOTE: The break-in function is turned OFF automatically
when turning transceiver's power OFF.
"BK" appears
Advertisement
Table of Contents
