Table of Contents
Advertisement
4
DV MODE PROGRAMMING
D Station call sign programming
Station call sign must be programmed to call a specific sta-
tion as well as for repeater operation in both digital voice and
low-speed data communications.
q Enter "UR" in call sign screen.
MENU
CALL-S
(Push [MENU
• UR call sign screen is displayed.
w Rotate [DIAL] to select the desired call sign memory,
"U01" to "U60."
e Push [ ](LOW) to enter call sign programming mode.
• The 1st digit blinks.
r Rotate [DIAL] to select the desired character or code.
• Push [ ](LOW) or [ ](CS) to move the cursor right or left, re-
spectively.
32
UR
]), (rotate [DIAL], then push [ ](MONI).)
t Repeat the step r to enter the desired station call sign.
• Up to an 8 digit call sign can be set.
• If an unwanted character is entered, push [ ](LOW) or [ ](CS)
to select the character, then push [CLR](DR) to erase the se-
lected character, or push and hold [CLR](DR) for 1 sec. to erase
all characters following the cursor.
y Push [ ](MONI) to store the programmed call sign and
return to UR call sign screen.
u Push [MENU
] to return to frequency indication.
For your information
The ID-E880 has a call sign edit record function.
When editing a call sign stored in a call sign memory (or reg-
ular memory/call channel), the default setting is to store the
edited call sign into a blank channel automatically. (When all
call sign memories are already programmed, the edited call
sign will overwrite the selected channels call sign.)
The programmed call sign can be over-written when the set-
ting of "EDIT R" (Edit record) is set to OFF or SEL.
However, you must manually over-write a reprogrammed call
sign in regular memory/call channels (temporary operation
without over-writing is possible).
(p. 135)
Advertisement
Table of Contents
