Basic Tv Operations; Sleep Timer - Zenith SENTRY 2 SL2722RK Operating Manual & Warranty

OPERATING YOUR TV
BASIC TV OPERATIONS _-
Selecting Channels by Using CHANNEL (CH) Up/Down:
You may select a channel through channel scanning by using
CHANNEL (CH) Up/Down. Only channels stored in the
channel scan sequence can be selected.
Selecting Channels by Using Numbers on Remote: Press
the numbers corresponding to the channel desired, then
press ENTER (ENT). Any channel in the band chosen can
be selected through direct number entry.
FLASHBK (Flashback) on Remote: Press FLASHBK to
return to the last TV channel you were watching.
Adjusting Volume: You can adjust the volume of your TV
by using VOLUME (VOL) Up/Down.
Muting Volume: To mute the sound coming from your "IV,
press MUTE on the remote control. To restore sound,
press MUTE again.
Selecting AUX _ on TV: Press CHANNEL (CH)
Up/Down until you select the next channel after the highest/
lowest channel, or enter the number 999 from the remote con-
trol, or press SOURCE on the remote control if available. You
will see program material provided by your VCtL camcord_r, or
other video equipment connected to the AUX INPUT VIDEO
and AUX INPUT AUDIO RIGHT and LEFT jacks on the
TV. For best picture performance using the AUX channel the
TV/Video (VCR) switch on your VCR should be set to the
Video (VCR) position. Use the AUX channel for viewing
video tapes.
After an Extended Power Outage: If you previously used
AUTO CH. SEARCH, you do not have to use it again un-
less you permanently changed the connections to the TV.
All of the channels previously found are stored in protected
memory, and are not affected by a power outage. However,
the clock must be reset to the current time.
CH 2
STEREO
Channe!/Audio Display
(Before Clock is Set)
CH2
10:56
MUTED
Channel/Time Display
While TV is Muted
MUTED
J
Mute Display *
CH2
10".56
,STEREO
Channel/Time/
Audio Display
(Al_r Clock Is Set)
VOL
Volume Display *
J
* VOL or MUTED display is
shown only when captions are
not being displayed.
SLEEP TIMER
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a 15 minute
pcriod up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER-to see status display.
2, Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing. The TV will shut off in one minute. The
display will count off the remaining seconds.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut off in one
minute.
3. Delay the shut off by using TIMER to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF. Press TIMER repeatedly until
status shows OFF.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the "IV.
0:15 GOOD NIGHT
0:58
Sleep Timer Display "Good Night" Display
z.,o $ -- 1