Operating Your Tv; Basic Tv Operations; Sleep Timer (On Some Models) - Zenith SENTRY 2 SLS9550S Operating Manual & Warranty

OPERATING YOUR TV
BASIC "IV OPERATIONS _
Selecting Channels by Using CHANNEL (CH) Up/Down:
You may select a channd through channel scanning by using
CHANNEL (CH) Up/Down. Only channels stored in the
channel scan sequence can be selected.
Selecting Channels by Using Numbers on Remote: Press
the numbers corresponding to the channel desired, then
press ENTER (ENT). Any channel in the band chosen can
be selected
through
direct number
entry.
FLASHBK (Flashback) on Remote: Press FLASHBK to
return to the last TV channel you were watching.
Adjusting Volume: You can adjust the volume of your TV
by using VOLUME (VOL) Up/Down.
Muting Volume: To mute the sound coming from your TV,
press MUTE on the remote control. To restore sound,
press MUTE again.
After an Extended Power Outage: If you previously used
AUTO CH. SEARCH, you do not have to use it again un-
less you permanently changed the connections to the TV.
All of the channels previously found are stored in protected
memory, and are not affected by a power outage. However,
the clock must be reset to the current time.
r
CH 2
Channel Display
(Before Clock is Set)
CtI 2
10:56
MUTED
Channe!/Time Display
While TV is Muted
MLrFED
CH2
10".56
J
Channel/Time Display
(Afl_er(;lock is Set)
VOL
Volume Display *
VOL or MUTED display is
shown only when captions are
not being: displayed.
Mute Display *
SLEEP TIMER (On Some Models)
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a period
from 15 minutes up to 4 hours.
To Set SLEEP TIMER
1. Pres_ TIMER to see status display.
2. Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1, Do nothing. The TV will shut off in one minute. The
display will count off the remaining seconds.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut off in one
minute.
3. Delay the shut off by using TIMER Lo select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLE;EP TIMER by setting the SLEEP
TIMER status to OFF. Press TIMER repeatedly until the
status shows OFF.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
0:15 GOOD NIGHT
0:58
Sleep Timer Display "Good Night" Display
2576-o 3 -- 1