Operating Your Tv; Basic Tv Operations; Sleep Timer - Zenith SYSTEM 3 Series Operating Manual And Warranty

OPERATING YOUR TV
BASIC TV OPERATIONS r --.
Selecting Channels by Using CHANNEL (CH) Up/Down:
You may select a channel through channel scanning by using
CHANNEL (CH) Up/Down. Only channels stored in the
channel scan sequence can be selected.
Selecting Channels by Using Numbers on Remote: Press
the numbers corresponding to the channel desired, then
press ENTER (ENT). Any channel in the band chosen can
be selected through direct number entry.
FLASHBK (Flashback) on Remote: Press FLASHBK to
return to the last TV channel you were watching.
Adjusting Volume: You can adjust the volume of your TV
by using VOLUME (VOL) Up/Down.
Muting Volume: To mute the sound coming from your TV,
press MUTE on the remote control. To restore sound,
press MUTE again.
After an Extended Power Outage: If you previously used
AUTO CH. SEARCH, you do not have to use it again un-
less you permanently changed the connections to the TV.
All of the channels previously found are stored in protected
memory, and are not affected by a power outage. However,
the clock must be reset to the current time.
S
CH 2
STEREO
Channel/Audio Display
(Before Clock is Set)
CH 2
10:56
MUTED
Channel/Time Display
While TV is Muted
MUTED
CH 2
10:56
STEREO
Channel/Time/
Audio Display
(After Clock is Set)
VOL
Volume Display *
* VOL or MUTED display is
shown only when captions are
not being displayed.
J
Mute Display *
SLEEP TIMER
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a 15 minute
period up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER to see status display.
2. Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing. The TV will shut off in one minute. The
display will count off the remaining seconds.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut off in one
minute.
3. Delay the shut off by using TIMER to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF. Press TIMER repeatedly until OFF
status appears.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
_ SLEEP TIMER -_
0:15
Sleep Timer Display
_ SLEEP TIMER -_
GOOD NIGHT
0:58
"Good Night" Display
ZS77-B 3 -- 1