Operating Your Tv; Basic Tv Operations; Sleep Timer - Zenith Sentry 2 Operating Manual & Warranty

OPERATING YOUR TV
BASIC TV OPERATIONS
Selecting Channels by Using CHANNEL (CH) Up/Down:
You may select a channel through channel scanning by using
CHANNEL (CH) Up/Down. Only channels stored in the
channel scan sequence can be selected.
Selecting Channels by Using Numbers on Remote: Press
the numbers corresponding to the channel desired, then
press ENTER (ENT). Any channel in the band chosen can
be selected through direct number entry.
FLSHBK or FLASHBK (Flashback) on Remote: Press
FLSHBK or FLASHBK to return to the last TV channel
you were watching.
Adjusting Volume: You can adjust the volume of your TV
by using VOLUME (VOL) Up/Down.
Muting Volume: To mute the sound coming from your TV,
press MUTE on the remote control. To restore sound,
press MUTE again.
Selecting AUX Channel m "IV: Press CHANNEL (CH)
Up/Down until you select the next channel after the highest/
lowest channel programmed in your TV, or enter the number
999 from the remote control, or press SOURCE on the remote
control if available. You will see program material provided by
your VCR, camcorder, or other video equipment connected to
the AUX INPUT VIDEO and AUX INPUT AUDIO RIGHT
and LEVI'jacks on the TV. For best picture performance using
the AUX channel the TV/Video (VCR) switch on your VCR
should be set to the V'mleo(VCR) position. Use the AUX chan-
nel for viewing video tapes.
After an Extended Power Outage: If you previously used
AUTO CH. SEARCH, you do not have to use it again un-
less you permanently changed the connections to the TV.
All of the channels previously found are stored in protected
memory, and are not affected by a power outage. However,
the clock must be reset to the current time.
CH 2
STEREO
CH2
10:56
STEREO
Channel/Audio Display Channel/Time/
(Before Clock is Set) Audio Display
(After Clock is Set)
CH 2
10:56
MUTED
J
Channel/Time Display
While TV is Muted
MUTED
J
Mute Display *
J
I
I
J
Volume Display *
* VOL or MUTED display is
shown only when captions are
not being displayed.
SLEEP TIMER
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a 15 minute
period up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER to see status display.
2. Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time );ou have a
choice of the following three actions.
1. Do nothing. The TV will shut off in one minute. The
display will count off the remaining seconds.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut offin one minute.
3. Delay the shut off by using TIMER to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF. Press TIMER repeatedly until the
status shows OFF.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
--SLEEP TIMER
0:15
Sleep Timer Display
---SLEEP TIMER ---]
GOOD NIGHT
0:58
"Good Night" Display
zs_-o 6 -- 1