Operating Your Tv; Basic Tv Operations; Sleep Timer (Remote Control Only) - Zenith SENTRY 2 SLS8549Y5 Operating Manual & Warranty

OPERATING YOUR TV
BASIC TV OPERATIONS
Selecting Channels by Using Channel Up/Down: You may
select a channel through channel scanning by using CHANNEL
(CH) Up/Down either on the remote control or on the con-
trol panel of the TV. Only channels stored in your favorite
channel scan sequence can be selected.
Selecting Channels by Using Direct Number Entry on
Remote: Press the numbers corresponding to the channel
desired, then press ENTER (ENT). Any channel in the
band chosen can be selected through direct number entry.
FLSHBK (Flashback) on Remote: Press FLSHBK to
return to the last TV channel you were watching.
Adjusting Volume/Muting Volume: You can adjust the
volume of),our set by using VOLUME (VOL) Up/Down.
To mute the sound coming from your set, press MUTE on
the remote control. To restore sound, press MUTE again.
After an Extended Power Outage: If you previously used
AUTO SEARCH, you do not have to use it again unless
you permanently changed the connectors to the TV. All of
the channels previously found are stored in protected
memory, and are not affected by a power outage. However,
the clock must be reset to the current time.
CH2
10".56
"Channel/Time Displa;
i
vo llllllllll;
_....,__ 1'
Volume Display
CH2
10-..56
MUTED
x... j
Channel/Time Display
Whille 'IV is Muted
MUTED
Mute Display
SLEEP TIMER (Remote Control Only)
You can program the TV to automatically shut off after a 15
minute period up to 4 hours, by using TIMER on the
remote control.
To Set SLJSEP TIMER
1. Press TIMER to see status display.
2. Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display aj_pears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing. The TV will shut off in one minute.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut off in one
minute.
3. Delay the shut off by using TIMER to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
SLEEP TIMER
0:15
GOOD NIGHT
PRESS TIMER
KEY TO CHANGE
Sleep Timer Display "Good Night" Display
zs97_o 4 -- 1