Fluke ESA601 Operator's Manual page 57

The Mains-on-Applied-Parts-Leakage-Current test is applicable only to
DUTs with applied parts.
Action
1. Position the
).
ISOLATION
2. Position the
3. Set the
POLARITY SWITCH
4. Connect the banana plug end of the RED test lead into the RED signal jack, and the
probe end of the RED test lead to the DUT enclosure; connect the DUT applied parts
to the applied-parts jacks on the ESA601; connect the DUT power cord to the test
receptacle on the ESA601.
5. Depress and hold down the
in the
NORMAL
6. After the meter settles, release the switch to hold and display the reading and/or press
the
PRINT SWITCH
7. Depress and hold down the
in the
REVERSE
8. After the meter settles, read the display, and/or press the
reading.
9. Set the
POLARITY SWITCH
to illuminate.
10. Repeat steps 5 through 8.
11. Set the
POLARITY SWITCH
12. Cycle the
APPLIED
number of leads that are connected), repeating steps 5 through 11 for each applied-
parts selection.
13. Disconnect all applied parts from the analyzer.
14. Using the probe end of the RED test lead, touch any exposed conductive part of the
DUT and wait for the meter to settle.
15. While keeping the probe end of the RED test lead connected to the DUT, read the
display, and/or press the
16. Repeat steps 14 through 15 for each exposed conductive part tested.
Note
-
FUNCTION SELECTION KNOB
- -
APPLIED PARTS SELECTION KNOB
to
NORMAL
. . ./
M A P VDE EQUIV
position.
to print the reading.
. . ./
M A P VDE EQUIV
position.
to
REVERSE
to
NORMAL
- -
PARTS SELECTION KNOB
PRINT SWITCH
Performing Electrical-Safety Tests
to
MAINS APPLIED PARTS
to .
ALL
, and wait for the analyzer to switch to normal.
/ ( /
INSUL ISO VDE EQUIV
/ ( /
INSUL ISO VDE EQUIV
PRINT SWITCH
, and wait for the
REVERSE POLARITY
, and wait for the analyzer to switch to normal.
from ( 1) through
RA AP
to print the reading.
Local Control
(
LEAD
/ )
INSUL SWITCH
/ )
INSUL SWITCH
to print the
indicator
6 ( 10) (or the
V AP
5
5-23