Table of Contents
Advertisement
Performing Electrical-Safety Tests
The following section contains test-principle diagrams (with notes on switches and
functions) and step-by-step instructions for performing the electrical-safety tests that are
available by positioning the ESA601
The following descriptions refer to holding down the
results. This is applicable only if a compatible printer is connected to the
ESA601 for this use.
Mains-Voltage Test
1. Position the
2. Power
the ESA601. The unit goes through boot-up initialization for three
ON
seconds. (The ESA601 displays error codes if the Mains are wired improperly or are
out of range.)
3. Position the
4. After the meter settles, read the display, and/or press the
reading.
Power to the ESA601 front panel outlet is off during the Mains-Voltage test.
FUNCTION
Note
-
FUNCTION
SELECTION KNOB
-
FUNCTION
SELECTION KNOB
Note
Performing Electrical-Safety Tests
-
.
SELECTION KNOB
PRINT SWITCH
to
.
OFF
to
(
MAINS VOLT VAC
MAINS
PRINT SWITCH
Local Control
to print
/
).
LINE VAC
to print the
5
5-9
Hide quick links:
Advertisement
Table of Contents
