Color Alarm - Fluke Ti100 User Manual

Ti100, Ti110, Ti125, TiR110, TiR125
Users Manual
To set the IR-Fusion mode:
1. Push V.
2. Push R/S to highlight Measurement.
3. Push U or Y to view the menu.
4. Push R/S to highlight Image.
5. Push U or Y to view the menu.
6. Push R/S to highlight IR-Fusion.
7. Push U or Y to view the menu.
8. Push R/S to highlight an option.
9. Push:
U to set the change and go back to the live view.
V or X to set the change and go back to the previous menu.
W to cancel the change and go back to the live view.

Color Alarm

The Imager has various apparent temperature color alarms (not applicable for
Ti100). The high-temperature color alarm shows a full visible image and only
shows infrared information on objects or areas that are above the set apparent
temperature alarm level. The low-temperature/dew point color alarm shows a
full visible image and only shows infrared information on objects or areas that
are below the set apparent temperature/dew point color alarm level. The user
must manually find and set these parameters. The imager also displays color
isotherms, or infrared information, inside or outside of a set of both high and
low limits.
The Imager does not sense ambient or surface dew point level
automatically. To use the low-temperature color alarm function as a
dew point color alarm, manual determination and input of surface
dew point temperature will yield the best results. Depending on the
situation, the colors presented will, or will not, actually show areas
with possible dew point condensation.
28
Note