Fluke Ti90 Quick Start

QuickStart:
Microphone & Speaker
Power Button
Function Keys
Arrow Keys
Battery
1. MEMORY:
Insert SD memory card into the slot under the rubber cover on the side of the camera.
2. POWER:
Insert a fully charged battery into the base of the hand grip. The battery life is indicated in the upper
left corner of the LCD display. You can also press and hold the battery symbol on the side of the battery.
3. START:
Press and hold the green power button (located above the LCD display screen) until you hear an
audible tone signaling camera startup.

Swing the attached lens cover up into the open position.

To turn the camera off, press the green power button until an audible tone signals it is powering down.
4. AUTO ADJUST:
set prior to the power being shut off after its last use. Auto or Manual will be displayed in the upper right
corner of the LCD screen indicating which adjustment mode is currently set.
If the imager starts up in Manual Mode:
1) Hold down the F1 BUTTON for 1 second to switch back to Auto Mode Or...
2) Press the F3 BUTTON once for a one-time Auto Adjust. This will automatically
adjust the image, but the camera will remain in Manual Mode.
© 2014 The Snell Group / 322 N. Main Street / Suite 8 / Barre, VT 05641 / 800-636-9820
Fluke Ti90/95/100/110/125 TiR110/125
(Level and Span) The default start-up image adjustment mode will be the one that was
Lens Cover
Visual Camera
and LEDs
AC Input, USB
& SD Card Slot
Primary Trigger
(Pause)
1
IR Camera Lens
Laser Pointer
IR‐OptiFlex
Secondary Trigger
(Laser & LED)
(Not Available On
90/95/100)
/ www.thesnellgroup.com
TM
Focus