Weider PRO 9645 User Manual page 14

ii
27. Locate the Low Cable (23). Route the Low
Cable under the 3 1/2" Low Pulley (102). Be
sure that the end of the Cable with the ball
Is on the Indicated side of the Press. Frame
(17) and that the Cable Is between the
. Pulley and the crossbar on the Press
Frame. "tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (not shown).
28. Route the Low Cable (23) around the 3 1/2"
Pulley (15) attached to the lower hole in the
Front Upright (42). See the Inset drawing.
Be sure that the Cable Trap (66) is turned
to hold the Cable In place and that the
Cable Is routed around the Pulley as
shown, "Rghten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (88).
29. Route the Low Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) Is turned to hold the Cable in
place and that the Cable Is routed around
the Pulley as shown. _ghten the 3/8" Nylon
Locknut (21) and the 3/8" x 3 1/2" Bolt (not
shown).
30. Route the Low Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Front Upright (42). See the Inset drawing.
Be sure that the Cable Trap (66) Is turned
to hold the Cable In place and that the
Cable Is routed around the Pulley as
shown. Tighten the 3/8" Nylon Locknut (21)
and the 3/8" x 3 3/4" Bolt (88).
<
23
17102
23
_ Ball
--17
88--
6
42--
Inset shows view
from other side
J
23
--66
--17
J
6
Inset shows view
from other side
14