Table of Contents
Advertisement
:_
(15) and a Cable Trap (66) to the upper hole ;n
_
24. See the inset drawing. Attach _-3 ij2" Pulley
a Long "U"-Bracket (57) with a _8" x 2" Bolt
(12) and a 318" Nylon Locknut (21). Be sure
that the Cable Trap is inside the Long "U"-
Bracket• Note: This may come pro-assem-
bled.
?:c
Route the High Cable (58) through the Long
"U"-Bracket (57) and the 3 1/2" Pulley (15)
shown in the inset drawing. Be sure that the
Cable is in the groove of the Pulley and that
the Cable and Pulley move smoothly,
25. Wrap the High Cable (58) around a 3 1/2"
Pulley (15). Attach the Pulley to the bracket on
the Top Frame (55) with a 3/8" x 2" Bolt (12)
and a 3/8" Nylon Locknut (21). Be sure that
the Cable is In the groove of the Pulley and
that the Cable and Pulley move smoothly.
26. Note: This assembly step shows how to
complete the assembly of several pre-
attached parts.
The 5/8" x 9116" Spacer (7) has been pro-
attached on the outside of the 3 1/2" Low
Pulley (102) for shipping purposes. Remove
the 3/8" Nylon Locknut (21), the Spacer, and
the Pulley from the 3/8" x 3 3/4" Bolt (88). Do
*_
,'_._:'..,,_._',:e ,?.,:{t• ;':_o Bolt has been
shown removed for pa_ identification.
Reattach _e 3 1/2' Low Pulley (102), with the
5/'8" x 9/16" Spacer (7) between the Pulley and
the Press Frame (17). Do not tighten the 3/8"
Nylon Locknut/q!)
y_.. Be s:_r_ that the
3/8" x 3 3/4" Bolt (88), the 3/8" Flat _,',_sher
(9), the 5/8" x 9/16" Spacer (7), the 3 ;/2"
Low Pulley (102), and the 3/8" Nylon
Locknut (21) are oriented as shown.
24
25
26
Bracket
58
•j12
13
Hide quick links:
Advertisement
Table of Contents
