Weider PRO 4900 User Manual page 9

10. identify the Front Weight Guides (136), which
have the Hockhobs cioser to the center than the
Rear Weight Guides (24). Orient the Weight
Guides with the hobs cioser to the bottom.
Attach the Front Weight Guides (136) to the Right
Base (1) with an M10 x 155mm Boit (130), two
M10 Washers (116), and an M10 Nyion Locknut
(114).
SUidetwo Weight Bumpers (65) onto the Front
Weight Guides (136). SUidethe ten Weights (35),
with the pin hobs on the indicated side, onto the
Weight Guides.
Press a Weight Tube Bumper (66) into the Long
Weight Tube (36). insert the Weight Tube into the
stack of Weights (35). Make sure the pin on the
Weight Tube sits in the groove on the top
Weight.
Grease the indicated hobs in a Top Weight (34)
with an [ncHuded grease pack. SHidethe Top
Weight onto the Front Weight Guides (136).
Repeat this step with the Rear Weight Guides
(24) and eight Weights (35).
11. Attach the Right Top Frame (7) to the Right
Upright (4) with two M8 x 80mm Boits (94), two
M8 Washers (117), and two M8 Nyion Locknuts
(115). Do not tighten the Locknuts yet.
Attach the Right Top Frame (7) to the Left Top
Frame (8) with two M8 x 80mm Bolts (94), two
M8 Washers (117), and two M8 Nyion Locknuts
(115). Do not tighten the Locknuts yet.
10
136
Lock
Hobs
11
24
_66 !_
Groove
130 6 114
116 1
117
94
i
9