Table of Contents
Advertisement
41, Wrap the Leg Lever CaMe (70) under a 90mm
Pulley (39), Attach the Pulley and two Half Finger
Guards (42) to the Right Base (1) with an MIO x
48mm BoUt(101) and an MIO Nylon Locknut
(114), Make sure the Finger Guards are orient-
ed as shown.
42, Wrap the Leg Lever CaMe (70) over a 90mm
PuUUey (39), Attach the PuUUey, a SmaUU CabUe Trap
(48), and two Half Finger Guards (42) at the sec-
ond hole from the bottom of the two Pulley Hates
(51) with an MIO x 52mm BoUt(102) and an MIO
Nylon Locknut (114), Make sure the CabJe Trap
and Finger Guards are oriented
as shown.
43, Wrap the Leg Lever CaMe (70) under a 90mm
Pulley (39), Attach the Pulley and two Half Finger
Guards (42) to the "U"-bracket on the Right Base
(1) with an MIO x 48mm BoUt(101) and an MIO
Nylon Locknut (114), Make sure the Finger
Guards are oriented
as shown and are on the
outside
of the "U"-bracket.
44, Wrap the Leg Lever CaMe (70) under a 90mm
Pulley (39), Attach the Pulley, a Small CaMe Trap
(48), and two Half Finger Guards (42) to the
bracket on the Right Base (1) with an MIO x
52mm BoUt(102) and an MIO Nylon Locknut
(114). Make sure the CabJe Trap and Finger
Guards are oriented
as shown and that the
bracket
is between the Pulley and the Finger
Guard next to the Locknut.
45, Route the Leg Lever Cable (70) up through the
Right Top Frame (7), over a115mm Pulley (41),
and back down through the Top Frame, Attach
the Pulley inside the Top Frame with an MIO x
80mm Bolt (111), two MIO Washers (116), two
19mm Spacers (77), and an MIO Nylon Locknut
(114),
41
114
\
44
45
111
39
42
7O
17
Hide quick links:
Advertisement
Table of Contents
