Weider PRO 4900 User Manual page 23

67, SHde the Pad Tube (31) through the Right Seat
Frame (9), SHde two SmaHH Foam Pads (32) onto
the Pad Tube, Press two Foam Caps (58) into the
Pad Tubes,
Repeat this step with the Leg Lever (!1}.
68, Attach the Knee Pad (30) to the Dip Assist (21)
with four M6 x 16mm Screws (85),
67
68
\
\
\a
9
32 /
58
3O
21
85
69, Make sure that aHH parts have been properHy tightened, The use of the remaining parts wHH be expHained in
ADJUSTMENTS, beginning on the foHHowing page,
Before using the weight system, puHH each came a few times to make sure that the cabHes move smoothHy
over the puHHeys, H fone of the cabHes does not move smoothHy, find and correct the probHem, IMPORTANT: If
the cabtee are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any sJack
in the caMes, you wilt need to remove the stack by tightening the cables. See MAINTENANCE on
page 29.
23