Weider PRO 4900 User Manual page 19

51, Route the Right Stack Cable (70) down through
the Right Top Frame (7) and over a 90mm Pulley
(39), Attach the Pulley and a Small Cable Trap
(48) inside the Top Frame with an MIO x 80mm
Bolt (111), two MIO Washers (116), a 19mm
Spacer (77), a 16mm Spacer (124), and an MIO
Nylon Locknut (114), Make sure the 16ram
Spacer and the Small Cable Trap are on the
same side of the Pulley.
52, Set an M12 Washer (129) on top of the Long
Weight Tube (36), Thread an M12 Nut (128) all
the way onto the Right Stack Cable (68),
Thread the Right Stack Cable (68) into the Long
Weight Tube (36), Tighten the M12 Nut (128)
against the M12 Washer (129),
53, Locate the Press Cable (69}. Grease an M8 x
86mm Shoulder Bolt (86), Attach the Cable to the
Leg Press Frame (12) with the Bolt, an M8
Washer (117) and an M8 Nylon Locknut (115),
54, Wrap the Press Cable (69) around a 90mm
Pulley (39), Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an
MIO Washer (116) to the Left Seat Frame (10)
with an MIO x 103mm Bolt (106), an MIO Washer
(116), and an MIO Nylon Locknut (114), Make
sure the CabJe Trap and Finger Guards are
oriented as shown.
55, Wrap the Press Cable (69) around a "V"opulley
(40), Attach the "V"opulley, two Half Finger Guards
(42), and two MIO Washers (116) to the Leg
Press Frame (12) with an MIO x 118mm Bolt
(100), an MIO Washer (116), and an MIO Nylon
Locknut (114), Make sure the Finger Guards
are oriented as shown.
53
55
48
42
86
39 116
116
42
117
42
116
116
19