Weider PRO 4900 User Manual page 16

36, Grease an M8 x 22mm ShouUder BoUt(88), Attach
the Ab CaMe (72) to the bracket on the Right
Upright (4) with the BoUtand an M8 NyUon
Locknut (115), Make sure the fiat edge of the
Cable is against the bracket on the Upright
37, Locate the Leg Lever Cable (70). Route the
CaMe through the Leg Lever (11) and the Right
Seat Frame (9), Make sure the CaMe is over the
rod in the Seat Frame,
Attach a 90mm Pulley (39) inside the Leg Lever
(11), over the Leg Lever CaMe (70), with an MIO
x 65mm BoUt(96), two MIO Washers (116), two
12mm Spacers (75), and an MIO NyUon Locknut
(114),
38, Attach a 90mm PuUUey (39) inside the Right Seat
Frame (9), over the Leg Lever CaMe (70), with an
MIO x 45mm BoUt(138) and an MIO NyUon
Locknut (114),
39, Route the Leg Lever CaMe (70) through the Right
Upright (4) and under a 90mm Pulley (39), Attach
the Pulley and two HaUl Finger Guards (42) to the
Right Base (1) with an MIO x 48mm BoUt(101)
and an MIO NyUonLocknut (114), Make sure the
Finger Guards are oriented as shown.
40, Wrap the Leg Lever CaMe (70) over a 90mm
Pulley (39), Attach the Pulley and two HaUlFinger
Guards (42) to the Double "U"obracket (52) with
an MIO x 48mm Bolt (101) and an MIO Nylon
Locknut (114), Make sure the Finger Guards
are oriented as shown.
36
37
38
39
4O
Flat
Edge
116
7O
114
\\
114 42
114
72
\
115.
/
39 7O
88
116
75
96
39
101
42
16