Weider PRO 4900 User Manual page 18

46. Set an M12 Washer (129) on top of the Short
Weight Tube (123). Thread an M12 Nut (128) aH
the way onto the Leg Lever CaMe (70).
Thread the Leg Lever CaMe (70) into the Short
Weight Tube (123). Tighten the M12 Nut (128)
against the M12 Washer (129).
47. Locate the Right Stack CabJe (68}. Attach the
CabUe to the Left Top Frame (8) with an M8 x
80mm BoUt(94), an M8 Washer (117), and an M8
NyUon Locknut (115).
48. Wrap the Right Stack CabUe (68) under a 90mm
Pulley (39). Attach the Pulley, a Small CaMe Trap
(48), and two HaUl Finger Guards (42) to the
upper hoUein the indicated "U"-bracket (50) with
an MIO x 52mm BoUt(102) and an MIO NyUon
Locknut (114). Make sure the Cable Trap and
Finger Guards are oriented as shown.
49. Wrap the Right Stack CaMe (68) over a "V"°puHey
(40). Attach the "V"°puHey and a CaMe Trap (49)
to the Left Top Frame (8) with an MIO x 55mm
BoUt(137) and an MIO NyUonLocknut (114).
Make sure the CabJe Trap is oriented to hold
the Carte in the groove of the Pulley.
50. Wrap the Right Stack CaMe (68) around a 90mm
Pulley (39). Attach the Pulley and a Small Cable
Trap (48) to the Right Top Frame (7) with an MIO
x 110mm Bolt (73) and an MIO Nylon Locknut
(114).
46
5O
t73
68
18