Weider PRO 4900 User Manual page 12

19, Attach the Leg Bumper (76) to the Right Seat
Frame (9) with an M4 x 16mm Serf-tapping Screw
(113) and an M4 Washer (131),
Grease an MIO x 75mm BoUt(104), Attach the
Leg Lever (11) to the Right Seat Frame (9) with
the BoUtand an MIO NyUon Locknut (114), Make
sure the "U'-rod is on the indicated side of
the Leg Lever. Do not over tighten the
Locknut; the Leg Lever must be able to pivot
easily.
20, HoUdthe Dip Assist (21) around the Rear Upright
(6) and Left Upright (5) as shown, Make sure the
Dip Assist is under the indicated rod.
Attach the Cross Brace (64) to the Dip Assist (21)
with an MIO x 232mm BoUt(108), two MIO
Washers (116), and an MIO NyUon Locknut (114),
Grease an MIO x 232mm bout (108), Attach the
Dip Assist (21) to the Left Upright (5) with the BoUt
and an MIO NyUonLocknut (114), Do not over-
tighten the Locknut; the Dip Assist must be
able to pivot easily.
Attach the Dip Assist Latch (67) to the Dip Assist
(21) with an MIO x 85mm Bolt (107), two MIO
Washers (116), a 12mm Spacer (75), and an MIO
NyUon Locknut (114), Do not overtighten the
Locknut; the Dip Assist Latch must be able to
pivot easity. Engage the Latch over the rod on
the Rear Upright (6),
21, Wet the lower end of the Left Butterfly Arm (18)
with soapy water, Slide a Large Foam Pad (79)
onto the Butterfly Arm,
Note: an entire grease packet shouJd be used
for this step. Grease an MIO x 86mm Bolt (92)
and the indicated edges of two Arm Bushings
(59), Attach the Left Butterfly Arm (18) to the
Butterfly Frame (22) with the Bolt, an MIO Large
Washer (134), the two Arm Bushings, and an
MIO Nylon Locknut (114), Make sure the bott
head fits inside the hote in the Butterfly
Frame.
Repeat this step with the Right Butterfly Arm
(17).
19
2O
21
116
17
11
114
92 Grease
59
18
114/'_
12