Troubleshooting - Troy-Bilt 1924 Owner's Manual

TROU B LES H OOTi NG
Probmem
No AC output is avaHabme, but
generator is running.
CaU$_
I. One of the drcuit breakers is
open.
2. Fault in generator.
3. Poor connection or defective cord
seL
4. Connected device is bad.
Correction
1. Reset drcuit breaker.
2. ContactAuthorized service facHit7.
3. Check and repair.
4. Connect another device that is in
good condition.
Generator runs good at no-load 1. Short circuit in a connected load. I. Disconnect shorted electrical load.
but "bogs" down" when loads are 2. Generator is overloaded. 2. See "Don't Overload Generator".
connecteds 3. Shorted generator circuit. 3. ContactAuthorized service facilit_
Generator will not start_ or starts Low oil [eve[. Fill crankcase to proper [eve[ or place
and runs roughs generator on [eve[ surface_
1. Out of gasoline. 1. Fill fuel tank.
Generator shuts down during
operation, 2. Low oil level, 2. Fill crankcase to proper level or
place generator on level surface.
Generator lacks powers Load is too high. See "Don't Overload Generator".
4@