Grizzly G0514X Owner's Manual page 60

symptom possible Cause
Blade tracks 1. tracking is not adjusted properly.
incorrectly, or
2. Wheels are not coplanar.
comes off wheels.
3. Blade tension is too loose.
4. Blade guides need adjustment.
5. Feeding workpiece too fast.
6. incorrect blade for bandsaw.
7. Blade is bell-mouthed, worn or dull.
8. rubber tire on wheel is damaged or worn.
the cut is crooked, 1. the feed pressure is too high or the blade
or the blade
speed is wrong.
wanders (blade
2. the blade tension is low.
lead).
3. the blade is dull or damaged.
4. inadequate blade support.
5. incorrect blade for application.
6. the blade tracking is wrong.
7. table is loose.
8. Fence or miter slot out of alignment with
blade.
9. Blade guide alignment at fault.
-58-
possible solution
1. adjust tracking (page 23).
2. adjust wheel coplanarity (page 65).
3. increase blade tension (page 31).
4. adjust blade guides (page 33).
5. Feed workpiece slower (page 39).
6. install correct blade for machine.
7. install new blade, and de-tension blade when not in
use.
8. replace rubber tires.
1. adjust feed rate and cutting speed as required.
2. increase the blade tension (page 31).
3. replace the blade (page 49).
4. adjust upper blade guide so it is as close as
possible to workpiece (page 33).
5. use wider blade.
6. adjust the blade tracking back to normal.
7. tighten table trunnion mounting bolts or tilt lock
lever.
8. align table miter slot and fence with blade.
9. adjust blade guide bearings for correct blade
support.
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)