G0514X2B - Grizzly G0514X Owner's Manual

G0514X2B

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
crate contents (figure 15–17):
A. Bandsaw (not shown) ................................. 1
B. table ........................................................... 1
c. Miter gauge ................................................ 1
D. standard Fence assembly ......................... 1
E. resaw Fence ............................................. 1
f. resaw Fence lock lever M8-1.25 x 45 ..... 1
G. resaw Fence t-Bar .................................... 1
h. Front square rail ........................................1
I.
sliding plate.................................................1
J.
table tilt handwheel ...................................1
K. guide post handwheel................................1
hardware and Tools (not shown):
• Bandsaw Blade 6 tpi hook 143" ................1
• eye Bolt M10-1.5 (may be installed) ............1
• Flat Washers 8mm
(table, sliding plate, Fence) .......................8
• lock Washers 8mm (table) ........................4
• hex Bolts M8-1.25 x 25 (table) ...................4
• hex Bolt M8-1.25 x 55 (sliding plate) ..........1
• lock nut M8-1.25 (sliding plate) .................1
• Cap screws M6-1 x 12 (sliding plate) .........2
• hex Bolt M8-1.25 x 90 (pos. stop) ..............1
• hex nuts M8-1.25 (pos. stop, Fence) .........2
• table pin......................................................1
• table insert ..................................................1
• Cap screws M6-1 x 16 (Fence) ...................2
• hex Bolts M6-1 x 20 (Fence) .......................2
• Fence handle M8-1.25 x 22 (Fence) ...........1
• rail pad M6 x 18 (Fence) ............................1
• hex nut M6-1 (Fence) .................................1
• lock handle M8-1.25 x 44 (Fence) .............1
• Moving plate (Fence)...................................1
• lock Washers 6mm (Fence, sliding plate) .4
• Flat Washers 6mm (Fence, sliding plate) ...4
• hex Wrench 5mm & 8mm ..................... 1 ea
• open end Wrench 10 x 13mm ....................1
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
Qty
figure 15. Bandsaw components.
Qty
figure 16. Fence components.
i
figure 17. Foot brake and table tilt components.
B
d
g
F
h
j
C
e
d
K
-17-