Install The Clock Lithium Cell - RCA CC9381 User Manual

¢@nnec @ns Setup
Install the Clock Lithium Cell
The supplied lithium cell must be installed f\)r the camcorder to remember the date and
time settings.
1.
Card slot cover
3.
CARD OPEN Lithium cell
4.
button holder
5.
Slide the CARD OPEN button in the direction of
tile arrow to open the card slot cover.
Pull out the cell bolder using the tip of a
ballpoint pen or other pointed object.
Insert the lithium ceil into the cell holder with
the + side of the ceil facing the + side of the
holder.
Insert the cell holder back into the compartment.
Close the card slot cover.
To Remove the Clock Lithium Cell
Peribrm steps 1 and 2 above, and Iili out the lithium
cell fiom the cell holder.
Notes."
Set the date and time after inserting a
lithium cell Not setting the date and
time causes extra wear on the lithium
cell
Replace the cell with a new CR2025
lithium cell when the time display starts
to fall behind the correct time.
Important: Lithium cell battery. Replace only with 3-volt lithium cell-such as
CR2025, Use of other cell presents a risk of fire or explosion, Must be disposed of
properly, Never handle punctured or leaking cell May cause burns or personal
injury.
Keep out of the hands of children. Can cause death or injury if swallowed, If
swallowed, consult a physician immediately for emergency treatment.
The Lithium cell used in this device may explode resulting in a fire or chemical burn
if mistreated Do not recharge, disassemble, heat above 212_F (!00_C), or incinerate
Never use metallic tweezers to hold the cell, and never short circuit the + and -
sides of the cell
Chapter _
25