Edit Netcommand®: Add An A/V Receiver - Mitsubishi Mr.Slim WD-52627 Owner's Manual

Edit NetCommand®: Add an AiV Receiver
A/V Receiver Screen
Figure 8
If your A/V Receiver manufacturer was not Histed, and you
seHected "None" during the initiaH NetCommand setup,
you may add the A/V Receiver and have NetCommand
Heamits remote controFs functions. Either seHect Edit
from the Finish screen or, if you have finished the initiaH
setup, go to the Main menu, seHect NetCommand, then
press ENTER. The Edit NetCommand screen will display.
SeHect Add.
Figure 8. AiV receiver screen
However, NetCommand will not be aMe to controH
this device. Later you may use the "Change" option
in the NetCommand menu to Heam the remote controH
signals.
After seHecting Next>, the screens that follow are: the AiV
Receiver Input screen (Figure 8), Name screen (Figure 11),
Audio Output to AVR screen (Figure 12), ending with the
Finish screen (Figure 13).
Choose ONE of these options:
Select a recognized manufacturer. The model
number optimized for NetCommand will display at
the bottom of the screen. If a number follows the
manufacturer's name, (example: Mitsubishi 1), this
indicates additional models are optimized for that
manufacturen For many device types, non-listed
models will operate in the same way as the listed
models and you can still use the preqoaded setting.
After selecting Next>, the screens that follow are:
the Name Screen (Figure 12), Audio Output to AVR
screen (Figure 13), ending with the Finish screen
(Figure 14).
Select "Other", then highlight "Learn" and press
ENTER. This will allow you to have NetCommand
learn the remote control signals of this new device.
After selecting "Learn" and pressing ENTER, the
screens that follow are: the AiV receiver Inputs
screen (Figure 9), AiV Receiver Input Learn screen
(Figure 10), AiV Receiver Learn screen (Figure 11),
Name screen (Figure 12), Audio Output to AVR
screen (Figure 13), ending with the Finish screen
(Figure 14).
Select "Other," skip Learn and select Next>. This
will allow the device to appear and will allow
NetCommand to switch inputs to use this device.
A/V Receiver inputs
Figure 9
If you select "Other" as the manufacturer and then
"Learn," you will see the AiV Receiver Input screen. After
selecting the number of inputs, this screen will not appear
again.
Depending on your A/V Receiver's capability, you may
connect up to seven AiV inputs. Select the number of
inputs by pressing ADJUST _k or V.
If the number of connected inputs changes, you will need
to delete the AiV receiver through Edit NetCommand and
add it again, as described above.
Figure 9. AiV receiver input screen
Chapter 3. NetCemmand Setup and Editing 45