A/V) Receiver - Mitsubishi VS-5075 Owner's Manual

Projection TV + home theater (A/V) receiver
A home theater (A!V) receiver
has video inputs
and outputs and is
used to control an A/V system. See yc_ur receiver's owner's guide for
information about connecting VCRs and other equipment. If your
receiver does not have video inputs aad outputs, turn to page 40.
equipment you will need
• one set of RCA pin-type audio
cables,
one RCA pin-type video cables
(to complete step O below), and
• either one S-video cable OR one
RCA pin-type video cable to
complete step O.
procedure
0 Connect one end of a video cable tc the TV VIDEO INPUT
terminal of the home theater receiver. Connect the other end of
this cable to the TUNER VIDEG OUTPUT terminal on the
back of the Projection TV.
O
Do ONE (not both) of the followiag:
• Connect a video cable to the VIDEO MONITOR OUT
terminal on the back of the receiver. Connect its other end to
the INPUT-1 VIDEO INPUT terminal on the Projection TV.
• Connect an S-video cable to the S-VIDEO OUT terminal on
the VCR. Connect the other end of this cable to the
INPUT-1 S-VIDEO INPUT terminal on the :Projection TV.
Connect audio cables to the TV AUDIO INPUT terminal of the
home theater receiver. Use the red. cable to com_ect the right
(R) channel and the white cable to connect the ].eft (L) channel.
O Connect the other ends of these cables to the left and right
TUNER AUDIO OUTPUT term:inals on the Projection TV.
38 Chapter 2: Connecting Your Projection TV