Antenna With A Single Lead; Antennas With Separate Uhf And Vhf Leads - Mitsubishi Mr.Slim WD-52627 Owner's Manual

Connecting an Antenna with a Single Lead or Antennas with
Separate UHF and VHF Leads
Antenna with a Single Lead
(not for use with CabIeCARD
TM}
Figure
3
For antennas with flat twin leads
A 300-Ohm to 75-Ohm transformeris required. This is not
included with the TV, but is available at most electronics stores,
1. For an antenna with flat twin leads, connect the
300-Ohm twin leads to the 300-Ohm to 75-Ohm
transformer.
2. Push the 75-Ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For cable or antenna with coaxial lead
Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
81H,-OI_r "J_-_hm
TV I_ect(Ixltm N_n
Figure 3. Connecting a Single Antenna
Antennas with Separate UHF and VHF
Leads
Figure 4
A UHF/VHF combiner is required, This is not included with the
T_:
1_ Connect the UHF and VHF antenna leads to the UHFi
VHF combiner,
2_ Push the combiner onto ANT-1 MAIN on the TV back
panel,
VHF Antenna UHF Antenna
(Channels 2-13) (Channels 14-69)
- Flat Twin Lead
External
Antenna
or Cable
-- Flat Twin Lead
TV back panel section
-7
TM
-•n _
00Oh mto :
I 75 Ohm
Combiner 2,
Back Side
.
T
View View
To ANT 1/MAIN
Figure 4, Connecting separate UHF and VHF Antennas
lVlitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.
Chapter 2. Connecting 25