Mitsubishi Mr.Slim WD-52627 Owner's Manual page 110

Appendix H: Lamp Cartridge Rep(acement, continued
A
BURN DANGER!
During normal operation, the surfaces inside
the TV near the (amp are extrenqeiy hot.
TOUCH THE LAMP CARTRIDGE BY THE HANDLE ONLY
Do not touch the glass parts of the (amp cartridge.
1. Turn TV power off and a((ow lamp to cool at least one
hour before proceeding.
2. Remove the plastic air exhaust gr(((eicover by
removing two screws with a #2 (large) Ph((((ps
screwdriver. See figure 1.
3. With a large fiat-blade screwdriver, comp(ete(y loosen
the three shiny screws securing the lamp cartridge
until they disengage from the mating threads.
These are captive screws and cannot be removed
comp(ete(y from the lamp cartridge.
4. Grasp the wire handle of the lamp cartridge and pu((
the old cartridge straight out towards you. Note the
orientation of the cartridge. See figures 2 and 3.
5. Do not touch the glass parts of the new lamp
cartridge. Oils from your fingers on the glass could
cause premature failure of the lamp. Insert the new
cartridge into the TV in the same orientation as the
old cartridge. Push on the cartridge housing until it is
fully seated.
8. With either your fingers or the screwdriver, gently
tighten the three screws. If using a screwdriver,
only use two fingers for final tightening. AVOID
OVERT(GHTEN(NG!
9. Replace the plastic grille/cover and retaining screws.
10. This lamp contains mercury. Do not dispose of old
lamp with common trash. For disposal or recycling
information, please contact your local authorities or
the Electronic Industries Alliance at www.eiae.com.
ONLY REPLACE LAMP CARTRIDGE WITH THE SAME
PART NUMBER 915P026010.
THE GRILLE/COVER IS PROVIDED WITH AN INTERLOCK
TO REDUCE THE RISK OF EXCESSIVE ULTRAVIOLET
RADIATION. DO NOT DEFEAT ITS PURPOSE OR
ATTEMPT TO SERVICE WITHOUT REMOVING GRILLE/
COVER COMPLETELY.
Figure I. Removal of the exhaust grille
Figure 2. Remova! of lamp cartridge
Handle
Figure 3. Lamp-cartridge handle
To order a new (amp under warranty, ca(((800) 332-2119. P(ease have mode( number,
seria( number and TV purchase date avai(ab(e. To order a new (amp after warranty, ca((
{800} 553-7278 and order (amp part number 915P026010.
1 1 0 Apperldiees