Mitsubishi Mr.Slim WD-52627 Owner's Manual page 44

NetCommand ® Initial Setup, continued
Review Screen
Figure 6
After you have made your device choices, the Review
Screen will dispHay. It is important to review the settings
to ensure that they are correct. If necessary, you can
use <Back to return to the Device Setup screen to make
changes.
Figure 6. Review screen
Finish Screen
Figure 7
To compHete the NetCommand setup, seHect Finish
from the Finish screen.
Hfyou wish to change any of the pre- configured
inputs or names for the devices, or add devices not in
the pre-configured setup, seHect Edit to display Edit
NetCommand menu.
Hfyour A/V receiver was not Histed, seHect Edit to add
the AVR and then assign aH devices to new AVR inputs.
Note: The Review screen Histsthe TV input and AiV
receiver input used with each device. You must
correctly identify the inputs you used when you
connected the devices. If you have not connected
your devices, write down these inputs as a guide. If
you cannot use these inputs, or if you would like to
change the name of a device, use the instructions in
Edit NetCommand to make necessary changes.
Note: If you select Next> on the Review screen, all
selections made are finalized.
On the Review screen, adding or deleting check marks
will turn the adjacent devices or inputs On or OfL 1394
device names only appear on the Review screen when
the devices are connected to the TV.
Figure Z Finish screen
It may still be necessary to memorize the available
channels for Antenna-1 (and Antenna-2, if used).
You may do that by going to the TV Main menu and
selecting Setup. Instructions to memorize channels are
found in the Setup menu section.
Chapter 3. NetCommand Setup and Editing