Wall Outlet Cable; Standard Cable Box - Mitsubishi Mr.Slim WD-52627 Owner's Manual

Connecting a Wail Outlet Cable or Cable Box
Wall OutJet CabJe
(can be used with a CabJeOARD
TM)
Figure 1
It is very important to connect the incoming cabb
for your primary vbwing source to ANT-l, especially
for CabbCARD
TM
use and to downioad TV Guide On
Screen® iistings.
Connect the primary incoming coaxiai Headcabb to
ANT l/MAIN on the TV back panel.
2.
3.
For an optional secondary antenna source, connect
an antenna (or cable) to ANT 2/AUX.
If you have subscribed to a CableCARD
TM
service,
the CableCARD can now be inserted into the
CabieCARD SLOT. Using a Phillips screwdriver,
remove the CableCARD cover screws. Insert the
CableCARD, then replace the cover and screws. The
top of the card should face in the direction the CARD
TOP arrow indicates.
Additional CableCARD information is on page 20.
Detailed TV Guide On Screen information is in the
separate User's Manual.
I
T_T_
II I
II
III1_ i!111111_
Figure I. Waft Outlet Cable
Standard Cable Box
(analog cable box, other than an HDTV cable box,
compatiMe with PIP)
Figure 2
3 coaxial cables and one two-way RF splitter are required,
These are not included with the T_/I
Note: See page 29 to connect an HDTV cable box.
1. Connect the incoming cable to IN on an RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to IN on the analog cable box.
4. Connect one coaxial cable from OUT on the cable
box to ANT-2 AUX on the TV back panel.
5. After the cable box is connected to ANT-2 AUX
as shown, open NetCommand and go to the RF
Connection for Cable screen and do the following:
a. Check the RF check box.
b. For antenna, select ANT-2.
c. For Channel, select the channel to which the TV
must be tuned for your cable box. The default
channel is 3.
When this setup is complete, you can use the TV remote
control to change channels on the cable box.
J
n
roll
_m
Figure 2. Connecting a CaMe Box
Note: To use a cable box connected to ANT-2 as
shown above, you must make the noted NetCommand
changes. The changes are required to change
the NetCommand cable-box default connection
(Componentq) to the actual connection (ANT-2).
Chapter 2. Connecting