Chapter 2: Connecting; External Devices And Netcommand® Setup - Mitsubishi Mr.Slim WD-52627 Owner's Manual

Connecting E×temai Devices and NetCommand® Setup
NetCommand is able to control many current audio and video devices by sending remote control signals from the TV
to each device through IR emitters. Additionally, it is also able to barn the remote control signals used by most audio
video devices not already in the TV's memory. NetCommand can automatically switch the TV and compatible or
learned Audio/'Video (A/V) Receivers to the correct input used with each device. It is important that the inputs on the
TV and AiV receiver back panels match the NetCommand setup that is displayed on screen.
To simplify the installation of NetCommand, there is a step-by-step on-screen NetCommand Setup procedure in this
chapter, which details the type and brands of devices you are connecting to the TV. The NetCommand Setup also
assigns preset TV and AiV receiver inputs for each device. You should connect each device to the TV input (both audio
and video) and to the AiV receiver (audio) as shown in the figure below. If you connect devices to inputs other than the
ones shown as presets, you must change the NetCommand setup accordingly. See the Edit NetCommand information
starting on page 47.
I
I I
The following charts show which preset inputs you should use on the TV and AiV receiver.
Chart 1 shows the default TV inputs existing in NetCommand.
Chart 2 shows the AiV receiver inputs used by AiV receiver models already known by NetCommand.
Chart 1
NetCommand Default Device Audio and Video Outputs to TV mnputs
Cable for CabmeCARD
TM
Service ANT=f
Antenna/Cable (digitaVanamog) ANT=I if primary viewing source,
ANT=2 if
secondary
viewing source
Cable box COMPONENT=f
VCR lnput=f
Satellite Receiver
(SAT) input-2
Camcorder
input-3 (on front panel)
DVD Player COMPONENT=2
PC HDMI=2
After using NetCommand Setup, you may go to the NetCommand menu at any time to change the inputs you used
for connecting each device, custom name devices, add devices not included in the presets above or delete devices
no longer used. See Edit NetCommand. See He/pfu! Hints at the end of this chapter for additional information on
device setup.
Chapter 2. Connecting