Wall Outlet Cable Or Cable Box - Mitsubishi WD-52525 Owner's Manual

Connecting a Wall Outlet Cable or Cable Box
Wall Outlet Cable
(can be used with a CableCARD™)
Figure 1
It is very important to connect the incoming
cable for your primary viewing source to ANT-1,
especially for CableCARD™ use.
1. Connect the primary incoming coaxial lead cable to
ANT-1 MAIN on the TV back panel.
2. For an optional secondary antenna source, connect
an antenna (or cable) to ANT-2 AUX.
3. If you have subscribed to a CableCARD™ service,
the CableCARD can now be inserted into the
CableCARD SLOT. Using a phillips screwdriver,
remove the CableCARD cover screws. Insert the
CableCARD, then replace the cover and screws.
Additional CableCARD information is on page 18.
TV back panel section
2. Optional
Secondary
Antenna
L
or Cable
R
HDMI
M-LINK
1. Primary
Wall Outlet
Cable
CableCARD
SLOT
(cover removed)
Figure 1. Wall Outlet Cable
IMPORTANT
Additional connection cables are
not provided with the TV. They are
available at most electronic stores.
IR EMITTER
NetCommand
R
DVI
Analog Audio
ANT-2
AUX
DTV/
CABLE/
VHF/
UHF
ANT-1
MAIN
M-LINK
CONTROL/
RS-232C
DIGITAL
AUDIO
3.
TM
CARD
TOP
Cable Box
(compatible with PIP/POP)
Figure 2
3 coaxial cables and one two-way RF splitter are required.
These are not included with the TV.
It is very important to connect the incoming
cable for your primary viewing source to ANT-1,
especially for CableCARD™ use.
1. Connect the incoming cable to IN on an RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to IN on the cable box.
4. Connect one coaxial cable from OUT on the cable
box to ANT-2 AUX on the TV back panel.
Cable Box
back panel section
IN
OUT
1.
Incoming
Cable
Figure 2. Connecting a Cable Box
Note: Net Command® will assume that your
Cable Box is connected as shown above. Also,
that Channel 3 is the default output channel
for the cable box. If either the connections or
output channel are different, use the Change
option of Edit NetCommand to apply the
changes.
TV back panel section
3.
IR EMITTER
NetCommand
4.
L
Analog Audio
4.
R
3.
HDMI
M-LINK
2.
M-LINK
CONTROL/
RS-232C
2.
R
DVI
ANT-2
AUX
DTV/
CABLE/
VHF/
UHF
ANT-1
MAIN
17