Maytag BRAVOS MGD6600TQ0 Use & Care Manual page 14

Check t he
levdness of the dryer by first placing a levd oil the top of the dryer near the
console.
Then, by placing a level ill the crease on the side of the dryer between the top of the dryer and
the dryer cabinet, check the levelness from front to back.
3. Loosen the top screw from each of the 2 hinges ill Step 2.
,A
B
A
'B
If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs
up or down and check again for levelness.
You can change your door swing from a right-side opening to a left-side opening, if desired.
1. Place a towd or soft cloth on top of the dryer or work space to protect the surface.
Remove the door assembly
1. Open the dryer door.
2. Remove the bottom screw from each of the 2 hinges that attach the dryer door to the front
panel of the dryer.
A. _oos(!ll th@se SCI'@VVS.
_. R@mov(! thE!s(! 5cr_!\,vs.
4. Remove the dryer door and the hinges by lifting upward on the door. I.ay the door on a
flat, protected surface, with the inside of the door facing up. Remove remaining 2 loose
screws from dryer front panel.
5. Remove the 4 plastic plugs located outside the dryer door opening.
6,
II
---)_,,,- (
II
--a_-c
I
k
Install 4 plastic plugs into screw holes in the dryer left where the hinges were removed in
Step 4.
14