Panasonic Palmcorder IQ PV-D326 Operating Instructions Manual page 9

I
DC Power Cable
1
DC IN J[. Connect the VCR DC OUT on
Pv'__ector"'"= _ ' *'-- the AC Adaptor to the DC IN on
the Palmcorder with the DC
Power Cable (supplied).
V Plug in the AC Adaptor.
• The POWER Lampwill lightup.
Note:
• AC Adaptorcan notbe used to powerthe Palmcorderwhile chargingthe Battery.
• While not in use, unplugthe AC Adaptorfrom the AC outlet. (AC Adaptorconsumes
1.2W of electricpower if it is pluggedintoan AC outlet even when notin use.)
DC IN
Connector
Cigarette Lighter
Socket (1 :V)
Car Battery Cord Cigarette
(optional) Lighter Plug
Connect a PV-C16 Car Battery Cord
(optional) to the DC IN of the
Palmcorder.
Start your car engine and then_ Insert
the Car Battery Cord plug into your
cigarette lighter socket.
• There is a fuse located in the lighter plug
end of the cord.
Should fuse replacement be necessary
use the exact current rating (in amps).
Note:
* This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord. If you are not sure check with your local
car/truck dealer as to what type of DC battery
ground you have in your vehicle.
o Be sure to start your car engine before
inserting the cigarette lighter plug of the
Car Battery Cord into the lighter socket;
otherwise, the cigarette lighter plug fuse
may burn out.
• Because the car is running while your
Palmcorder is in operation, make sure
you're in a well ventilated area.
• Disconnect the cigarette lighter plug when
your Palmcorder is not being used.
9