Table of Contents
Advertisement
Your Palmcorder may be connected to a
TV to play back tapes or to view what you
are recording.
_TV
with AUDIO/VIDEO
IN Jacks.
)
To Audio In
Audio/Vide0
Cable
(Supplied)
To Audio/Video
Out
Before
you begin...
• Connect
the Palmcorder
to a power
source.
Set the POWER switch to VCR to
playback a tape.
Or, set to CAMERA to view what your
Palmcorder is recording.
Turn the TV ON and set it to LINE
INPUT.
Check your TV operating instructions
for further information.
Note:
If yourTV has no VIDEO or AUDIO IN
Jacks, select CH 3 or 4 on your TV to match
the RF AdaptorCH 3/4 switchand set the
VCR/'I'V selectoron the RF Adaptor to VCR.
Start playback or begin a recording.
CTV without AUDIO/VIDEO IN Jacks..,_
To Audio
/Video Out
RF Adaptor
(optional)
VHF Antenna
CH 3/4 Switch
VCR/TV
Selector
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
300 ohm-75 ohm
transformer
(not supplied)
or F Connector
UHF Antenna
Back of TV
i/Ir01.
amtil/i ,Jl i,-
If you have connected the Palmcorder
to your TV using an RF Adaptor:
Set the POWER switch
to OFF on the
Palmcorder.
Then, set the VCRrI'V Selector on
the RF Adaptor to TV.
Now, turn the TV ON and select a
channel.
i
J
i
i
_CATV System
Installer
This reminder Is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
.cable entry as practical.
25
Hide quick links:
Advertisement
Table of Contents
