Panasonic Palmcorder IQ PV-D326 Operating Instructions Manual page 21

Table of Contents

Advertisement

Whenever the Palmcorder has been in Record/Pause
mode for 5 minutes, it will auto-
matically go into Stand-by mode to conserve power. To resume recording, it is necessary
to turn the Palmcorder POWER switch to OFF and then to CAMERA. Or, you may use
the following feature to avoid having to turn the Palmcorder off and on again.
This feature allows you to resume record-
ing from Stand-by mode by simply pressing
the RECORD/PAUSE
button.
Before you begin...
• Connect the Palmcorderto a power source.
• Insert a cassette with record tab (see page 10).
DISPLAY
RECORD/PAUSE
' While pressing the UP • button, set
the POWER switch to CAMERA.
Press UP • more than 2 seconds to
display the STAND-BY
RELEASE
selection screen.
BY RECORD/PAUSE
KEY
LI_CT:PUSH V/A
: PUSH
DISPLAY
KF
Press UP • or DOWN • as
necessary to select I_£R'_I
Press DISPLAY to set your selection
and exit this screen.
• You may now turn the Palmcorder
back on after it has gone into Stand-
by mode by pressing the RECORD/
PAUSE button.
Note:
If _
was selected in step 3
above, you must set the POWER switch to
OFF and then to CAMERA to resume
recording from Stand-by mode.
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Palmcorder iq pv-d426

Table of Contents