Panasonic Palmcorder IQ PV-D326 Operating Instructions Manual page 34

Before you begin...
• Connect the Palmcorder as shown below.
• Connect the Palmcorder to VCR.
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
Insert a pre-recorded tape
into the source (playing)
Palmcorder and a blank tape with
record tab into the recording unit.
Se* the Pa moor er POWER s i*ch to VCR Press PLA* on*he paying
L
Palmcorder. Press STILL when the
tape reaches the point you want to start
F-E_ _ dubbing.
Press PLAY and REC together
then immediately press STILL on
Source (Playing) the recording unit.
Palmcorder
II
STOP REW PLAY FF REC
VCR Buttons
AuO'oN"eoOu* TV ll]
Cable To View)
(supplied)
_VHF Connecting Cable
(not supplied)
Press STILL on the playing
Palmcorder and PAUSE/STILL
on the recording unit to begin
copying your tape.
Press STOP on both units
when dubbing is complete.
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
34
Note:
• Tapes recorded on other VCRs and
used for playback in the Palmcorder
must be recorded in SP or SLP mode.
• For technical reasons, dubbing a tape
may reduce its quality.
i CAUTION: fl
nauthorized exchanging and/or copying o
opyrighted recordings may be copyright
ffingement.