Panasonic Palmcorder IQ PV-D326 Operating Instructions Manual page 7

Charge theBattery Pack
fully
before operation.
®
POWER
Lamp
CHARGE
Lamp
Note:
After rechargingthe Battery Pack about 5 times,
use the BATTERY REFRESH feature as
explainedon page 8.
Plug in the AC Adaptor.
POWER Lamp lights up.
Insert the Battery
(_) Align the right side of the Battery
with the line on the AC Adaptor.
(_) Press down on the Battery and then
slide it in the direction of the arrow.
CHARGE Lamp lights up. It goes out
when charging is done (about one and
a half hours).
Remove the Battery
Slide the Battery out and then lift up.
• The useful operation time of the Battery will
gradually decrease after repeated use and
recharging. The Battery is no longer
seryiceable if the operation time is very short,
even after a sufficient charge.
With a fully charged Battery Pack, you will have a maximum of about one and a half
hours of continuous use. (If the Built-in Light is used, battery operating time decreases.)
- C . _,_1 Attach the Battery
-jl_]__) (_ Align the Battery with the top of the
I _ IY),/ mounting surface.
@ P_ce_,.s it into place until it locks with a
Remove the Battery
While sliding the BATTERY RELEASE
button, remove the Battery.
7