Lens Cap And Grip Belt; Attaching The Shoulder Strap; Inserting A Cassette - Panasonic Digital Plamcorder PV-DV901 Manual

3
Lens Cap and Grip Belt
To protect the Lens surface, attach the Lens Cap. Adjust the length of the
Grip Belt to the size of your hand.
1 Attach the longer loop of the Lens Cap Cord to the Lens
Cap.
2 Attach the shorter loop to the grip belt.
3 Put your hand through the Grip Belt and adjust the length.
oThe removed Lens Cap can be hooked onto the gripbelt O. (When you are
not recording, be sure to keep the Lens Cap attached to the Lens for
_rotection.)
Attaching the Shoulder Strap
We recommend that you attach the Shoutder Strap before going out of doors
to record so aK to avoid dropping the Palmcorder,
1" Pass the tip of the Shoulder Strap through the Shoulder
Strap Holder on the Palmcorder end pull the Shoulder Strap.
2 Fold the tip of the Shoulder Strap, pass it through the
Shoulder Strap Length Adjuster, and pull it.
• Puft it out more than 1 inch (2 cm) O from the Shoulder Strap Length
Adjuster so that it cannot slip off.
4
Inserting a Cassette
When power is supplied to the Palmcorder, the cassette can be taken out
without turning the Palmcorder on.
1 Slide the [OPEN/EJECT] Lever _) to the right and pull down
.to open the Cassette Compartment.
2
Insert a Cassette.
3 Close the Cassette Compartment and lock the Cassette
Compartment by pressing the [PUSH TO CLOSE] mark.
4
Close the Lower Cassette Compartment Cover.
• For other notes, see page St,
IAccidental Erasure Prevention
Opening the accidental erasure prevention slider O on the cassette (by
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC] arrow direction.)
13