Power Supply; Charging Time And Available Recording Time - Panasonic Digital Plamcorder PV-DV901 Manual

4
Power Supply
IBUsing the AC Adaptor
1 Slide theViewfinder backward and then tilt it upward.
2 Insert the battery.shaped connector of the DC Input Lead
into the Battery Holder on the Palmcorder.
3 Connect the DC connector plug to the [DC OUT] Jack on the
AC Adaptor.
4 Connect the AC Adaptor and AC Cable.
mUsing the Battery
• Before use, fully charge the battery.
| Attach the Battery to AC Adaptor and charge it.
• Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
iThe [CHARGE] Lamp lights up, and charging starts.
• When the [CHARGE] Lamp goes off, charging is completed.
_' Attach the charged Battery to the Palmcorder.
Disconnecting the Power Source
Set the [OFF/ON/MODEl Switch to [OFF] and, while pressing the
[BATT.EJECT] Button O, slide the Battery or DC Cable upward to
disconnect it.
• For other notes, see page 51.
Charging Time and Available Recording Time
(_) Charging Time
(_) Maximum Continuous Recording Time
• "1 h 20 rain." indicates 1 hour and 20 minutes.
• Battery PV-DBP9A is supplied (PV-DV901),
Battery PV-DBP8A is supplied (PV-DV851).
• The hours shown in the table below are approximate hours, The numeric
characters in parentheses indicate the recording time when the LCD
monitor is used, in actual use, the available recording time may be shorter
in some cases.
• The hours shown in the table below are for continuous recording at a
temperature of 68 °F (20 °C) and humidity o160 %. If the Battery is charged
at a higher or lower temperature, the charging time may become longer.
CGR-D08A/1B
PV-DBPBA ® 1 h.
_) 1 h 20 mln, (1 h 5 mln.)
CGR-D16N1B
® 2h.
_) 2 h 50 min, (2 h 15 mln.)
CGP_D28/V1 B
® 3 h 15rain.
_) 4 h 50 m|n. (3 h 55 mtn.)
CGR-D53NIK
CGR_8815A/1B ® 5 h 20 rain.
_,,,,, _) 9 h 10 mtn.(7 h 40 mtn.)