Ethernet Protocol Settings; Using The Software - Extron electronics CrossPoint 450 Plus Series User Manual

Ethernet protocol settings

The IP Settings/Options window (fi gure 5-5 on page 5-7) provides a location for
viewing and, if connected via the RS-232 link or if logged on via the Ethernet
port as an administrator, editing settings unique to the Ethernet interface. See
IP Settings/Options window later in this chapter for more details.

Using the software

Many items found in the Matrix Switcher Control Program are also accessible
via optional front panel controls (see chapter 3, Operation) and under SIS control
(see chapter 4, SIS Programming and Control). The Matrix Switcher Help Program
provides information on settings and on how to use the control program itself.
To run the Matrix Switcher Control Program, double-click on the
1.
Matrix Switcher Control Program icon (shown at right) in the
Extron Electronics group or folder.
The Comm Port Selection window (fi gure 5-1) appears.
Figure 5-1 — Comm port selection window
2. Choose either the comm port that is connected to the matrix switcher BME 0's
RS-232/RS-422 port, IP [LAN], or Emulate.
If you selected a comm port, check the baud rate displayed in the comm
port selection window. If you need to change the baud rate, click on the
Baud button and double-click on the desired baud rate.
Available rates are 9600, 19200, 38400, and 115200. The default is 9600.
Click OK and proceed to step 4.
If you selected IP [LAN], click OK and proceed to step 3.
If you selected Emulate, click OK and see Using emulation mode on
page 5-20.
CrossPoint 450 Plus and MAV Plus Switchers • Matrix Software
5-3