Setting The A/V Network - Mitsubishi CS-40805 Owner's Manual

Setting the A/V Network
The A/V Network is a special system that Mitsubishi developed to
make it easier to operate many products with one remote control.
When the A/V Network is connected between t:wo Mitsubis:hi
products, you can point the remote control at one product and it
will "pass" the remote control command to the other. To set up the
A/V Network:
[] FIRSTTIME SET UP
_ emorize Channels
Set the Clock
Add/Delete Channel
Set AN Network
Set up Cable Box
Use these buttons on the remote:
-'_--] ADJUST ENTER i'_ MENU to
to select -- to enter go back
[] SET A/V NETWORK
O AN Network: Active
When AN Network is
set to "Active" or
"Basic," your "IV can
perform automated
operations with other
Mitsubishi products.
Set to "OFF" if you do not have other
Active AJV Network products or are not
using an A/V Network control cable.
Use these buttons on the remote:
[_ ADJUST _ MENU to
to select go back
O Press the MENU buttola on the
remote control. The Main Menu
will appear on the screen.
O Use the ADJUST buttons to
select "First Time Setup." Press
the ENTER button.
Use the ADJUST buttons to
select "Set A/V Network." Press
the ENTER. button.
Use the ADJUST buttons to
select "Active," "Basic," or "Off."
Check the rear terminals of
your VCR, then use the chart
below to determine how you
should set your television.
Press the :?tOME button to
return to normal TV viewing.
If your VCR has a rear
terminal that reads:
A/V Network
Active A/V Network
Active A/V Network
Does not have an A/V
Network rear terminal
...and you have set your
VCR to:
off
Active
...then set your
TV to:
Basic
Basic
Active
Off
If you are not sure how to set :your VCR's AJV Network setting,
refer to your VCR's owner's guide.
34 Chapter 2: Operating Your Television