Mitsubishi CS-40805 Owner's Manual page 79

Troubleshooting (cont.)
Problems
Possible Solutions
For More Information
The remote control doesn't
work.
Check that the batteries are
installed correctly.
Check that the select button
is set to "TV."
Be sure that you are
pointing the tip of the
remote control toward the
TV from a distance of no
more than 20 feet.
See "Getting ready to use
the remote control" in
Chapter 1 for an explanation
of how t_ install batteries in
the rem,)te control.
See "Remote control buttons
and functions" in Chapter 1,
whicb explains where the
select buttons are located.
See "Getting ready to use
the remote control" i:a
Chapt;er 1, which contains
pointer_,_ for using the remote
control.
The TV takes several
seconds to respond to button
commands.
• Use the ENTER button to
avoid delays.
See "Changing channels" in
Chapter 2, which explains
the f_:nction of the ENTER
button.
You can't access a channel. • Be sure that the channel you
want to view is programmed
into memory.
• Check that the TV is tuned
to the correct input source
(antenna) for that channel.
See "Memorizing channels"
in Chapter 2, which explains
how to program channels
into th_ TV's memory.
See "SeLecting the input
source" in Chapter 2, which
explains how to change the
input source.
You can't see a different
channel in the reduced PIP
image.
Use the SOURCE button to
change the source of the PIP
image.
Use the small PIP CHAN-
NEL button to change the
channel of the PIP image.
• See "U_.ing the Advanced
Picture-in-Picture (PIP)
Modes" on page 66.
78 Chapter 4: Troubleshooting