Mitsubishi CS-40805 Owner's Manual page 77

Using the Active AN Network Feature
DImportant:
_>Important:
E>Important:
_>Important:
The A/V Network is a special feature that makes it easier tc use
your television and your other Mitsubishi A/V components to-
gether. When you connect the _ Network, yon can point the
remote control at the television, and it will "pa_s" the remote
control command to the other components.
Additionally, if you have a Mitsubishi VCR with Active A/V Net-
work, it is easier and faster VCR's play command (Auto Play).
The A/V Network is only available for select M[tsubishi
components. If you subscribe to StarSight, "Auto Play" is not
available.
before you begin
€" You must have connected an A/V Network cable from the Active
A/V Network terminal of your television 1:othe A/V Network IN
terminal of your VCR. See Booklet #1, "Mitsubishi
Installation and Setup Guide."
,z You must have connected your VCR to Input 1 of your TV.
J You must have set your television's "A/V N._twork" setting to
"Active" or "Basic." See "Setting the A/V N_twork," page 34.
€" Your VCR's remote control switch should b_ set to "VCR-A."
€" Your VCR's video mute setting should be turned ON.
When using the Active A/V Network, you should always point your
remote control at your television.
using Auto Play
When you press PLAY on the remote:
€" Active A/V Network will turn your VCR on and begin playing
the tape (if any).
J Active A/V Network will turn your TV on and switch it 1:o
INPUT-1.
When you turn your television off:
€" If your TV has been set to "Active," your V_DRwill turn off,
unless it is playing or recording.
If you leave the television turned on and:
- it is set to Input-l, and
- it does not receive a signal for five min_tes, and
- you do not use the menus for five minutes, then:
the TV will automatically turn off.
If you turn the TV off while it is set to Input>l, it will return to its
previous antenna and channel setting whe_ y_u turn it back on.
Using the Active A/V Network Feature 75