Setting The Av Network - Mitsubishi CS-35707 Owner's g Manual

Setting the AV Network
The AV Network is a system that Mitsubishi developed to make it
easier to operate many products with one remote control. When the
AV Network is connected between two Mitsubislhi products, you
can point the remote control at one product and it "passes" the
remote control command to the other. To set up the AV Network:
Timer Channels Captions Parent Lock D
I -Press E--_ER t omemorize channels, setthe time, oruse AV Network
I[1)Press the MENU button on the
remote control. The main menu
appears on the screen.
O Press ADJUSt' right until
Setup is highlighted.
miBm
• Active
O Basic
• off
4 SetClock AVNetwork
PressAT tOselect t hestatus ofAVNetwork
O Use the ADJUST left & riglht
buttons to select "AV Network."
Use the ADJUST up & down
buttons to select "Active,"
"Basic," or "Off." Check the rear
terminals of'your VCR, then
use the chart below to deter-
mine how you should set your
TV.
Press the MENU button to return to normal TV viewing.
_>Important:
_>Important:
[_Important:
If your VCR has a rear
terminal that reads:
A/V Network
Active A/V Network
Active A/V Network
Does not have an A/V
Network rear terminal
...and you set your VCR
to:
off
Active
...then set your TV to:
Basic
Basic
Active
Off
If you are not sure how to set your VCR's AV Network setting, refer
to your VCR's owner's guide.
The AV Network can still be used to pass remot;e control signals
even when the TV's "AV Network" setting is "Off."
If you do not use the AV Network system, set "AV Network" to
"Off." If you don't, channel selection may not work correctly.
If you select either the Active or Basic AV setting, make sure your
Mitsubishi VCR with an AV network or Active AV network connec-
tion is connected to Input-1 and the AV network cable is in place.
Operating Your TV 57